I'll run a little tap water on the outside of the cup and around the inside edge to loosen up the belt of ice holding the mold in the cup. I usually give it 24 hours to freeze and there will be an inch or two usable puck of clear ice under the mold. There is no problem getting the mold out of the cup.I keep as much water in the cup as possible, so there is water visible around the edge of the mold. Do this over the sink and the overflow runs down the drain. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |